Super-Grade valve rebuild


once the valve is disassembled and cleaned new seats are installed and valve re-assembled as follows



seats are pressed into recesses in valve body and striker guide



seat is placed on end of this tool and pressed in as shown below





new seats installed



tool used to seat ball valves as shown below



assembly is placed upright on vise anvil and tool is hit with hammer to seat ball



install valve components and use teflon tape to seal threads
firing pin shown at left



screw striker guide into valve body tightly and install quad seal or proper size o-ring



valve installed in rifle, charged with 6 pumps, removed and submerged in water to check for leaks

---------------------------------------------------------------